
AC Repair
Warm air, ice on the lines, water leaks or an AC that will not turn on.

Demo photo
Ask the expert
AC or heating trouble? Find out what to do next
This box uses AI. Your conversation is saved so our team can read it and reply. Privacy policy
Services

Warm air, ice on the lines, water leaks or an AC that will not turn on.

A furnace or heat pump that blows cold air or will not start.

A yearly check-up before each season, so the system runs well and lasts longer.

A new AC, heat pump or furnace, sized for your home by a load calculation.

Blank screens, wrong temperatures and smart thermostats set up right.

Humid rooms, musty smells, better filters and air cleaners.
Why Teadfast
Most repairs are booked within 2 business days.
Demo example: same-day repair visits are often possible on weekdays when you book before noon.
General liability insurance for damage to your home, and workers' compensation for workers hurt on the job.
Demo example: 1 year on parts and labor for repairs.
Service area
Pinewell and Montgomery County, Texas, including Conroe, The Woodlands, Magnolia and Willis.
All service areasDemo example. On your site, this links to your verified Google Business Profile.
Reviews
Sample rating: 4.8 out of 5 from 94 reviews.
Demo example. On your site, this shows your real Google reviews.
Our AC was running but blowing warm air on a 99-degree day. The technician found a clogged filter and a dirty outdoor coil, cleaned it, and showed me how to change the filter.
They did a load calculation instead of guessing from the square footage. The new heat pump is smaller than the old AC, and the house is less humid.
The furnace kept shutting off on the first cold night. They replaced the flame sensor the next morning and explained what had happened.
Questions
It is possible, but makers advise replacing the outdoor unit and the indoor coil, the part that gets cold, together. Outdoor units are designed to work with specific indoor units. An old indoor unit with a new outdoor unit can cause hot and cold spots and noisy startups. New equipment gets its maker's warranty, but parts you keep do not get new cover. We do a load calculation, which works out how much heat your home gains, before we size a new system. Estimates for a new system are free, with no obligation.
Check that the thermostat is on Cool and set below the room temperature, with the fan on Auto. Then check the air filter; a dirty filter is a leading cause of poor cooling. Look at the outdoor unit: its fan should spin, with grass and leaves cleared away. If it still does not cool, turn it off, because running it can damage parts. A licensed technician can check for low refrigerant (the fluid that carries heat) or a failed part. Teadfast Heating & Air repairs central ACs and heat pumps. Most repairs are booked within 2 business days. Demo example: same-day repair visits are often possible on weekdays when you book before noon.
When you hear a loud or unusual noise, turn the system off to prevent more damage. Squealing, grinding or banging often means loose parts or a worn motor. Rattling with strong shaking can mean a loose screw, a fan problem or an unlevel outdoor unit. Hissing near the indoor coil or copper lines can mean a refrigerant leak (a loss of the cooling fluid). Note what the noise sounds like and when it happens, for the licensed technician. Teadfast Heating & Air repairs central ACs and heat pumps. Most repairs are booked within 2 business days.
If the thermostat uses batteries, replace them first. Then check the circuit breaker, the system's power switch and that the furnace door is closed. If a breaker trips again after a reset, leave it off for a licensed technician. A waiting message usually means a delay that protects the compressor (the main outdoor pump), so wait about 5 minutes. Also check the mode and the set temperature. If the screen stays blank after these checks, a licensed technician should look at it. Teadfast Heating & Air installs and repairs thermostats, including smart thermostats. Most repairs are booked within 2 business days.
The right size comes from a load calculation of the home's heating and cooling needs, not square feet. A Manual J calculation, a detailed sizing method, looks at insulation, windows, ceiling height, sun, climate and people. An oversized system turns on and off too often and may leave the home clammy. An undersized one runs almost nonstop and may still leave rooms too hot. We do a load calculation, which works out how much heat your home gains, before we size a new system. Estimates for a new system are free, with no obligation.
Demo example: a repair visit has a diagnostic fee, and it goes toward the repair if you go ahead.
Leave your name and number, and tell us what you need.
Demo site: this form sends nothing.